Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

Recently, I have updated my board to SDK 10.00.00.08, and I have updated my Docker container accordingly from edgeai-tidl-tools I can compile and run ResNet-18 and MobileNetV2 on my TDA4 board without ...

TCAN4550 nINT中断到M3连接如上图所示。 M3想尽快收到CAN总线上的报文，以减少TCAN4550转换带来的通信延迟。 1、这里想通过nINT中断方式通知M3，当有外部中断来的时候，在M3的外部中断中进行接收 ...

I am using CCS version 11 and I would like to use SVN. I tried installing Subversive 4.0.5 from the Eclipse Marketplace, but the SVN Connector did not install properly and it didn't work. I also tried ...

Other Parts Discussed in Thread: AWR2243, 我在官方AM2732+2*AWR2243两片级联的Demo中导入了以太网模块，使能了CPSW，添加了PHY驱动以及LWIP协议栈。目前通过.map文件看下来，添加以太网模块前后MSS_L2空间占用 ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

I was failed to rebuild and download the Lab01 of UCD3138 on CCS. When I downloaded the original .x0 file to UCD3138CC64EVM-030, I can see the string contents through the memory debugger of UCD3138 ...

I am generating a sinusoidal signal of amplitude 5 and frequency 200 Hz using sine wave block of simulink in sample based mode and connecting the output to DAC block of embedded coder support package ...

Thank you in advance for any help that you can provide. I am running an app on the MSP-EXP430G2 Launchpad Development Kit with an older circuitco educational boosterpack. The app determines the speed ...

I need a DAC that can swing 0 to 3V3 and I only have 3V3 supply in my circuit. I was looking at DAC80501. It has a 2.5 internal reference and the datasheet says that "These devices include a 2.5-V, ...