Display – 0.96-inch OLED display with 128×64 resolution (SSD1306 I2C driver) Connectivity 802.11 b/g/n WiFi 4 up to 150 Mbps + Bluetooth 4.2 Classic and LE with “3D antenna” soldered on PCB, u.FL ...

Testing the OLED Display To test and make sure the display is working fine, first make the connections as per the connection diagram provided. Once it’s done, open the example program by navigating to ...

RAK12014 pinout Note: Only I2C pins, SHUT (reset), INT, 3V3_S, and GND are wired to the connector of this module. RAK12014 example: display distance on an OLED Display We’ll use RAK12014 in a very ...

Have the oled i2c SSD 1306 working with with 8.3.1 on a sonoff mini. But, it did not work properly on a Sonoff Basic. The problem with the basic is that the digits in the display do not overwrite, but ...

And on the basis of communication, mainly two types of OLEDs are available - 3pin and 7pin. 3 pin OLED can be used in I2C mode of communication and 7 pin OLED can be used either in SPI mode or in I2C ...

Hi, I am conducting a project that needs to use two SSD1306 OLED displays (both 128x64 resolution) with the same SCA SCL pins. I found that it can be achieved by changing the i2c address of one of the ...

Light meters, these days, are no longer a mystery: From home-improvement stores to eBay and Amazon you can find have at least a few units available for purchase. An open-source light meter, however, ...

This scanner displays the addresses of all attached I2C devices in a small matrix. The value is shiftet one bit to the left (and is therefore presented as an 8-bit address). The columns show the upper ...

This scanner displays the addresses of all attached I2C devices in a small matrix. The value is shiftet one bit to the left (and is therefore presented as an 8-bit address). The columns show the upper ...