There's a pressure hose from the pump to the control valve, while two smaller pressure hoses run between the control valve and the power ram. A low-pressure return hose travels between the control ...

Power steering was not available on Corvettes for the first 10 years of production. Equipped with skinny tires and small-blocks, ... Install the pump hoses, starting with the high pressure hose.

Now that the fluid looks clean, replace the low pressure hose and clamp, then refill the power steering reservoir [00 :03:00] to the full line once again. Before you tighten the cap, turn the ...

Perfect Power Steering - Pressure Point. ... Pressure hose connection: ... This can result from insufficient pump flow/pressure, low P/S fluid level, ...

NOTE: The power steering system uses a low-pressure hose on the return side of the system (steering gear back to the PS pump). Inspect this hose the same way you inspect brake or fuel system hoses ...

A rubber low-pressure line had to be trimmed to break loose from fitting where rubber had gotten hard. Doing the Switch To swap out your power steering pump, you should need only basic hand tools.

The low-pressure return hose is held in place with clamps. See All 16 Photos. 15The power steering pressure and return hoses were tied into the appropriate lines from the pump. Share.

WASHINGTON — Nissan is recalling more than 56,000 cars because of power steering hoses that may leak fluid and potentially lead to fires. Nissan North America says the recall affects the 2013 ...

In extreme cases, the belt can snap, creating a sudden loss of power and making the steering practically impossible. Aged Power Steering Pump. Occasionally, a power steering pump fails because it’s ...