2007 BMW 335i Sedan Road Test ... for synonyms for "stunning." Two exhaust pipes peer out below the rear bumper; aside from the 335i badging, they're the only tip-off to the turbo under the ...

For example, a lightweight titanium muffler for an R34 Nissan Skyline GT-R can easily cost upwards of $1,000, whereas some aftermarket and universal exhaust tips will only set you back around 1/10 ...

The 2012 BMW 328i (F30) is the replacement to the old ... chrome door sills and exhaust tips, ‘Luxury’ badges on the front guards, and a full leather interior. You can further opt for fine ...

But cars that do? They'll still wear their tailpipes proudly. Zelenskyy talks about possible condition of his resignation Adrien Brody Shuts Down Attempt to Cut Off His Oscars Speech: "Please Turn ...

BMW rates the 328i at 5.7 seconds to 60 mph ... red paint contrasting with gloss black accents and even a black chrome exhaust. Inside the sporty theme continues with Sport seats (featuring ...

In a sea of X3s, GLKs and Q5s, a car like the 2016 BMW 328i xDrive Sports Wagon sticks out. Mainly, I think it has to do with a stigma that hatchbacks and wagons aren’t cool. Crossovers are all ...

and secure it to the clay model as an exhaust tip. According to a 2004 story from Motoring File, It wasn't long before [Stephenson] was called on the carpet by his boss at BMW. "It wasn't the ...

Following the introduction of the M1 supercar at the end of the 1970s, BMW entered the 1980s on a tear, selling countless 328i spinners ... wheels and Magnaflow exhaust. The interior is swaddled ...

Check them out below: Also Read: Kitchen Tips: 4 Quick And Easy Ways To Clean Your Belan (Rolling Pin) The easiest way to get rid of greasy stains from your exhaust fan is to use a mix of hot water ...

That being said, the 2013 BMW 328i is really, really fun to drive. Although the 2013 isn’t the first model year of this the sixth generation 3 Series, it is my first opportunity to drive one.

How hard can it be? An exhaust tip looks to be such a simple thing to make. Take some sheetmetal, roll it into a cone, weld it up, and you're done, right? Well, it's not quite that easy ...