Hi, I'm reading and ADC from CC3235SF and I need to save the Serial Monitor data into a txt file. How can I do it? I tried doing it same as normal C, but it just doesn't create the file. No errors, no ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

Refer to bsl_software_invoke_app_demo_uart_LP_MSPM0G3507_nortos_ticlang, we want to duplicate the same method to enter BSL mode by invokeBSLAsm() on G3107. But MCU ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I already have the mcal code and SDK based on AM62Px, but I don't know which project uses this mcal, is there a freertos project based on mcal? The MCAL drivers and examples are baremetal for AM62P, ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

we are trying to add LAN9374 6 port ethernet switch to interface with the RGMII2. we have connected the spi0 of the am625 to the lan9374. in device tree under spi0 we have added a node for the lan9374 ...

Even though I enabled this configuration in Theia,I am not able to observe the energy trace in debug mode It appears that the configurations is showing as disabled. Could you please help me with this ...

We use the MMWCAS-DSP-EVM with the MMWCAS-RF-EVM (AWR1243 cascaded 4-chip radar module). Using MATLAB software, we plot range-Doppler maps by processing the captured data stored in bin files (outputs ...