Hi, I'm reading and ADC from CC3235SF and I need to save the Serial Monitor data into a txt file. How can I do it? I tried doing it same as normal C, but it just doesn't create the file. No errors, no ...

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I already have the mcal code and SDK based on AM62Px, but I don't know which project uses this mcal, is there a freertos project based on mcal? The MCAL drivers and examples are baremetal for AM62P, ...

Even though I enabled this configuration in Theia,I am not able to observe the energy trace in debug mode It appears that the configurations is showing as disabled. Could you please help me with this ...

We use the MMWCAS-DSP-EVM with the MMWCAS-RF-EVM (AWR1243 cascaded 4-chip radar module). Using MATLAB software, we plot range-Doppler maps by processing the captured data stored in bin files (outputs ...

During the charging and discharging process, the FCC value suddenly jumps to 0, but after a period of time it returns to a smaller value, or returns to a normal value Attached are the machine LOG and ...

Regarding UC3854 and UCD3138 used in the PMP20873 development board, we noticed that they both have three inputs: input voltage, input current, and output voltage. So what are the advantages and ...

Is there a way to check if the device is normal via the I2C interface? If so, please let me know. You can write to the output registers and read back the data to make sure I2C is functioning, but ...

Thank you in advance for any help that you can provide. I am running an app on the MSP-EXP430G2 Launchpad Development Kit with an older circuitco educational boosterpack. The app determines the speed ...