Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

Refer to bsl_software_invoke_app_demo_uart_LP_MSPM0G3507_nortos_ticlang, we want to duplicate the same method to enter BSL mode by invokeBSLAsm() on G3107. But MCU ...

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I am using CCS version 11 and I would like to use SVN. I tried installing Subversive 4.0.5 from the Eclipse Marketplace, but the SVN Connector did not install properly and it didn't work. I also tried ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

we are trying to add LAN9374 6 port ethernet switch to interface with the RGMII2. we have connected the spi0 of the am625 to the lan9374. in device tree under spi0 we have added a node for the lan9374 ...

Even though I enabled this configuration in Theia,I am not able to observe the energy trace in debug mode It appears that the configurations is showing as disabled. Could you please help me with this ...

im just getting started working on the API integration of my client to your Rest-API. As im setting everything up, i encountered several problems regarding your store-order-api.

3. Each converter utilizes two buses, resulting in a total of four LVDS buses being used. 4. Dual Clock Mode is disabled in DAC. 5. Data is sent by Xilinx high speed ...