Sterndrive bellows are rubber “boots” that seal out water around the exhaust, U-joints and shift cable ... housing in the full up position and loosen the screws for the two clamps at either end of the ...

Usually, these points are engine machining, paint, interior, and exhaust ... clamps are tightened just enough to keep things from falling apart—but not so tight that we can’t adjust the joints.

Exhaust design is often a tricky process ... and the front connections utilize a pair of stainless-steel flex joints with V-band clamps that will be attached to the downpipes coming off the ...

See All 35 Photos Next, Jeff used a 3-inch-diameter wheel mounted in an electric drill to blend the joint ... some angle iron and clamps, Jeff checked the exit end of the exhaust tips to make ...

MagnaFlow Performance mufflers are 100 percent polished stainless steel and lap joint welded for solid ... was ready to finish up the exhaust. 11.The exhaust clamps were tightened down to have ...

If your leak is along a joint or at the manifold ... they are usually simple bolt-and-clamp swaps that can be done with a set of basic garage tools. Exhaust leaks may seem like little more ...